Publicité
F E AT U R E S - O P E R AT I O N S
4. Replace the housing and tank. The tank will
immediately begin to empty into the base.
5. Plug the humidifier into a 120V electrical outlet.
6. To turn the unit on, switch the knob to either the High
(3), Med (2) or Low (1) setting. High will produce the
maximum moisture and Low will produce the longest
run time and quieter performance.
7. To turn the unit off, switch the knob to Off (O).
Figure 1
E
A
A Humidifier tank
B Humidifier Housing
C Control Knob
D Humidifier Base
Extended Run Time Setting:
Your humidifier is equipped with an extended run time
setting which increases the amount of time between tank
fillings. To take advantage of this setting, slide the switch
on the water tray all the way to right. For max output,
slide the switch back to the left.
REPLACING THE FILTERS
Through normal use, waterborne minerals and sediment
become trapped in the wick filter. The harder your water,
the greater the amount of minerals in the water, and the
more often you will need to change your filter.
All manuals and user guides at all-guides.com
F
B
C
G
D
E Tank Handle
F FilterCheck
TM
G. Extended Run Switch
You will be able to monitor the life of the filter in your
humidifier by checking the FilterCheck
the unit is off, the FilterCheck
OFF position. After 60 minutes of use, FilterCheck
Indicator (refer to Figure 2
for close-up of indicator) will
move from the OFF position
and indicate your filter
condition. A brand new filter
will register in the blue
section reading GOOD filter.
After frequent use of your
humidifier, the FilterCheck
Indicator will let you know
when the filter needs to be
changed.
When the needle is in the red (CHANGE) section, this
means the proper amount of moisture is not getting into
your air due to the excessive minerals and sediment that
have become trapped on your filter. At this point, you
should replace your filter. It is important to change your
filter as indicated to obtain stated performance level.
To replace the filter, follow the steps below:
1. Turn the unit off and disconnect from the
electrical outlet.
2. Remove the tank and main housing to access
the base tray.
3. Remove the wick and discard.
4. Follow the weekly cleaning instructions.
5. Insert new filter.
6. Repeat Operating Instruction steps.
It will take about 30 minutes for the humidifier to reach
maximum output.
You can purchase replacement filters (model SWF64) at
your local retailer, by calling 1-888-264-9669 , or by
visiting www.sunbeam.ca . It is recommended that a
replacement filter is purchased for uninterrupted use.
Indicator. When
TM
Indicator will read in the
TM
TM
Figure 2
TM
Publicité
