Elle BM928941044 Manuel D'instructions page 4

All manuals and user guides at all-guides.com
INTENDED USE
Warning! Only use the device externally.
• The appliance is only intended for drying and styling human hair.
• Any improper use can be dangerous!
• For best results, wash, comb and dry hair until just damp to touch – although the hair straightener can be used for touch ups
at any time. Do not use hairspray or other flammable chemical hair care products.
• Using four temperature settings will give you the desired effect whatever type of hair the appliance is used with. It is
advisable to use the low settings on fine hair and the higher settings on thick hair.
• Fully unwind the mains cable , and plug the straightener into the mains socket and switch on the product.
• Wait for 3 -5 minutes to allow the appliance to reach its working temperature.
• Divide hair into manageable sections and clip the upper layers on top of your head and out of the way. Work with underneath
layer first.
• Take a small section of hair and pull hair down and away from your scalp and hold it taut.
• Starting the roots, clamp hair firmly between the plates and run the straightener down the entire hair strand, from root to tip,
in one smooth stroke. Do not hold it in one area for a long period of time.
• Repeat with all the sections of your hairs.
• When you are finishing styling, slide the on/off switch to turn the unit off, unplug the unit and allow it to completely cool
down before cleaning or storing.
CLEANING
Unplug the appliance and allow it to cool down. Use a soft, slightly damp cloth to wipe the appliance surfaces. Do not allow
water or any other liquid to get into the unit. Care should be taken not to touch this part of the appliance when it is switched
on our just after it has been turned off. ALLOW AT LEAST 30 MINUTES TO COOL DOWN BEFORE PUTTING AWAY.
STORAGE
Unplug the appliance, allow to cool and store in its box or in a dry place. Never store it while it is hot or still plugged in. Never
wrap the cord tightly around the appliance. Never hang the unit by the cord. Store the cord loosely coiled. Do not put any stress
on the cord where it enters the unit, as it could cause the cord to fray and break.
4