Publicité
Les langues disponibles
Les langues disponibles
EN
Calibration check
Mount the laser level on a well-aligned tripod and align it as horizon-
tally as possible. The precision of alignment affects the size of the
slope range. Use the On/Off switch to switch on the device.
The levelling indicator flashes on the lit display.
If the tripod head is sloping by more than 5°, this is indicated by the
laser beam flashing quickly and the alarm symbol being displayed.
In this case, switch off the unit and align the tripod more carefully.
Once horizontal levelling is completed, the laser beam starts to ro-
tate.
Align laser level, along an approximately 30 m long measuring path,
starting with the X-axis.
At the end of the traverse length, make a mark at the level of the la-
ser beam. After this, rotate the laser unit by 180° and make another
mark. Then do the same for the Y axis. If all the marks are on top of
each other or are only slightly apart (maximum of 3 mm), adjustment
is OK. If the marks are a long way apart, you must get a specialist
firm to check the equipment and recalibrate it.
Adjustment
Switch on the laser
Press for five seconds
Adjustment mode is activated
Select the X axis. The selected axis flashes (X).
Use the arrow keys to adjust
Select the Y axis and adjust it like the X axis.
Switch off: The adjustment values are stored
All manuals and user guides at all-guides.com
3
Publicité
