Metrologic Optimus PDA SP5700 Serie Mode D'emploi page 7

Troubleshooting
Problem
PDA turns itself
PDA is in Sleep Mode.
off
Battery failed/end of life
Battery did not
PDA wasn't inserted into the Cradle
charge
properly
I/O Connector is not clean
Incorrect IP input
Fail to use WiFi IP Crashed
Lack of battery power
Tapping the
Temporary system error occurred
screen buttons or
icons does not
activate
LCD screen does not calibrate correctly
PDA is not inserted into Cradle correctly
Cradle is not connected
ActiveSync is not
working
ActiveSync installed incorrectly
Connected as a Guest not the name you
set
Volume setting is low
No sound is
audible
Speaker is not clean
A message
Too many files stored on the PDA
appears stating
that 'Memory Full'
Memory allocation is too low
Scan window is dirty or obstructed
Target barcode was moving while scanning
Scanning Program was not activated
PDA does not
Unreadable barcode
accept scan input
Distance between scan window and
barcode is incorrect
Barcode program doesn't recognize that
type of barcode
Scan under direct sunlight
All manuals and user guides at all-guides.com
Optimus PDA SP5700series Quick Start Guide
Cause
PDA turns off after a period of inactivity. The period can be set in
Settings-Power tab. By pressing the power button, The PDA will
return to the status it was before going in to sleep mode.
Change the battery.
If the PDA is still not active, perform a Hard Reset
Insert the PDA into the Cradle again to charge
Clean dust or rust with dry cloth
Check the static IP and set again
More than 2 PDAs are using the same static IP.
Ask your system manager for the correct IP settings
WiFi communication may fail when the battery is low
Execute Software Reset and recalibrate the Stylus in the
Settings-Stylus tab
Recalibrate Stylus pen In Settings-Stylus tab
Insert the PDA into the Cradle again and run ActiveSync
Check the cable connection status and authenticity of
the cable
Reinstall Active sync in the PC
Remove the PDA from the Cradle and re-insert.
Input the PDA name again
Check the volume slider in Settings
Remove dust in speaker
Transfer stored Data to PC or delete unused files
Adjust Memory allocation in the System-Memory
Gently clean scan window with soft cloth
Rescan the barcode without the bar code moving
Activate 'Run Scanner' in Settings-Barcode tab
Ensure the barcode is not defaced
Ensure you are within proper scanning range (15cm)
Ensure that the barcode program recognizes the barcode type
Lean the barcode to 45° direction or scan the barcode back
against the sunlight
Solution