Publicité
Les langues disponibles
Les langues disponibles
Adhesives
1.
Remove glue residue by rubbing toothpaste into
adhesive with fingers until adhesive loosens.
2.
Rinse surface with warm water. Dry surface with a
soft, clean cloth.
Door Gaskets
1.
Clean door gaskets every 3 months according to
"General Cleaning" instructions above. Clean any
spills immediately.
2.
Apply a light film of petroleum jelly to keep gaskets
pliable.
Condenser
Coils
Clean condenser coil every 3 months to ensure
maximum performance of refrigerator. Accumulated dust
and lint may cause the following:
• reduced cooling performance
• increased energy usage
• premature compressor failure
Remove lower front toe grille by holding ends and
pulling forward.
Clean front surface of condenser coil with a vacuum
cleaner hose nozzle.
Replace toe grille by inserting clips in holes and
snapping in.
.
2.
3.
CAUTION
To avoid property damage, protect soft vinyl or other
flooring with cardboard, rugs, or other protective
material.
4.
Pull refrigerator away from wall. Run a vacuum
brush across condenser fan outlet grille on back
of refrigerator.
Glass
Shelves
CAUTION
I
To avoid personal injury or property damage, handle
tempered glass shelves carefully. Shelves may
break suddenly if nicked, scratched, or exposed to
sudden temperature change.
Remove shelf by lifting front, releasing hooks from metal
track then pulling out. Place shelf on a towel. Allow shelf
to adjust to room temperature before cleaning.
Clean crevices by completing the following steps:
1.
Dilute mild detergent and brush solution into crevices
using a plastic bristle brush. Let set for 5 minutes.
2.
Spray warm water into crevices using faucet spray
attachment.
3.
Dry shelf thoroughly and replace shelf by inserting
hooks into metal track and lowering front.
Odor
Removal
1.
Remove all food and disconnect power to
refrigerator.
2.
Clean all interior surfaces including ceiling, floor, and
walls according to "General Cleaning" instructions.
Pay special attention to corners, crevices, and
grooves. Include all drawers, shelves, and gaskets.
3.
Connect power to refrigerator and return food to
refrigerator. Wash and dry all bottles, containers and
jars. Wrap foods in tightly sealed containers to
prevent further odor. After 24 hours, check if odor
was eliminated.
Complete the following steps if odor was not eliminated.
4.
Place crispers on top shelf of Fresh Food section.
Pack Fresh Food and freezersections
including
doors with crumpled sheets of black and white
newspaper.
5.
Place charcoal briquettes randomly throughout
newspaper.
6.
Close doors and let stand 24-48 hours.
7.
Remove charcoal briquettes and newspapers.
8.
Complete steps 2-3.
Contact Sears service center if odor was still not
eliminated. Refer to service section for phone number.
Light Bulb Replacement
11
WARNING
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before replacing light bulb. After
replacing light bulb, connect power.
CAUTION
To avoid personal injury or property damage,
observe the following:
• Allow light bulb to cool.
• Wear gloves when replacing light bulb.
Upper Fresh Food and Non-Dispensing
Freezer
Section
• Remove light bulb cover by removing IA" hex nut
screws. Replace bulb with 60-watt appliance bulb.
• Replace light bulb cover by replacing IA" hex nut
screws.
%
J
Light bulb
Light I: ulb cover
1/4" hex
nut
screws
Lower Fresh Food Section (some models)
• Remove light bulb cover by removing screw. Replace
bulb with 40-watt tubular bulb.
m
i11
Publicité
