Publicité
• Always be sensitive to the slightest gas odor. If you continue to detect any gas odor, no matter how small, treat it as a serious
leak. Immediately go into action as discussed previously.
ATTENTION ‑ CRITICAL POINTS TO REMEMBER!
• Propane (LP) gas has a distinctive odor. Learn to recognize these odors. (Reference Fuel Gas Odor and Odor Fading sections
above.
• Even If you are not properly trained in the service and repair of the heater, ALWAYS be consciously aware of the odors of
propane (LP) gas and natural gas.
• If you have not been properly trained in repair and service of propane (LP) gas then do not attempt to light heater, perform
service or repairs, or make any adjustments to the heater on the propane (LP) gas fuel system.
• A periodic sniff test around the heater or at the heater's joints; i.e. hose, connections, etc., is a good safety practice under any
conditions. If you smell even a small amount of gas, CONTACT YOUR FUEL GAS SUPPLIER IMMEDIATELY. DO NOT WAIT!
CAUTION: NEVER IGNITE AND / OR RUN THIS HEATER UNLESS THE SHELLS ARE FULLY EXTENDED AND LOCKED
INTO POSITION.
STEP 1
Remove heater from packaging. To protect your hands, put on
gloves before lifting the outer shell. Never grasp bare metal
without gloves.
STEP 2
Lift outer shell straight up. Care must be taken to protect hands
during lift.
WARNING: Never leave the heater unattended while operating.
Disconnect the heater from its power source when not in use.
GENERAL INFORMATION
ASSEMBLY
-7-
STEP 3
Lift outer shell until all three clips engage slots located in the
lower shell. When this happens, the screw holes will line up.
Make sure the clip
goes into the slots
in the lower shell
(3 places).
STEP 4
Lock the clip into place with 3 screws as shown. The heater must
not be operated unless the outer shell is properly extended and
fully locked into place.
Lock the shells together
with the clips in place
and with a screw in
each clip (3 screws
total).
Publicité
