Trust START-LINE ACDB-9000C Mode D'emploi page 6

EN
ACDB-9000C PORTABLE DOORBELL
Components
(1) LED indicator doorbell
(2) Pair button
(3) Volume button
(4) Melody button
Wireless control
The wireless doorbell can be operated wirelessly with
a minimum of 1 and a maximum of 32 Trust Smart Home
transmitters of your choice. For example, you can play
a desired melody using a push button. In addition, you
can also have a melody play when movement is detected
and/or when a window or door is opened. For each Trust
Smart Home transmitter you can set a separate melody to
hear exactly whether someone presses the push button
or whether a door or window is opened.
1. Insert batteries
A
Open the battery compartment of the doorbell by
turning the bottom towards the open lock icon.
B
Insert two 1.5V AA alkaline batteries (not included).
Pay attention to the correct polarity of the batteries
(place the plus and minus on the right side).
C
Place the bottom back on the doorbell.
When placing the bottom back on the doorbell, make
sure that the line on the bottom is lined up with the open
lock icon. Then turn the bottom to the closed lock icon.
2. Select desired volume
Press the volume button to select the desired
volume level. There are 4 levels:
High, Medium, Low and Disabled (LED Only indication).
6
This volume level applies to all registered
channels. You can change this volume level if desired.
3. Select desired melody
Then press the melody button to select 1 of the
6 melodies. You can set a separate melody per transmitter
(push button, motion detector, door/window sensor)
by selecting it beforehand.
4. Pair transmitter(s) to the doorbell
A
Do not press the pair button for more than 1 second
to activate the learning mode. The learning mode will
be active for 10 seconds and the LED indicator on the
doorbell will flash slowly.
B
While the LED indicator is flashing, send an ON signal
with a Trust Smart Home transmitter to link it to
the doorbell. For example, while the LED indicator is
flashing, you can press the push button (ACDB-8000A)
to pair it
C
As soon as the transmitter has been paired, the wireless
doorbell will give 2 short beeps. The transmitter,
melody and volume are now linked to the transmitter.
The wireless doorbell is now ready for use.
The doorbell can store 32 different transmitters in
its memory. If you want to link multiple transmitters,
you need to repeat steps 2 to 4
Unpair a Trust Smart Home transmitter
A
Press the pair button for 1 second. The learning mode
will be active for 10 seconds and the LED indicator on
the receiver will flash slowly.
B
While the learning mode is active, send an ON signal
with the associated channel of the Trust Smart Home
transmitter you want to remove.
C
.