Westfalia 81 84 65 Mode D'emploi page 23

5. Insert the new cutting shaft into the sliding block. Make sure the
fixing hole is located in the middle of the sliding block. Tighten the
fixing screw and nut.
6. Re-assemble the unit in reverse order: Install the cover and the
coil spring. Install the cutting shaft holders and secure them with
the fixing screws. Then screw the handle on the cutting shaft
holder (fig. 6).
7. Eventually perform a short test run.
Fixing Screw
and Nut
9
Coil
Spring
All manuals and user guides at all-guides.com
Operation
8
7
8
Body
6
Hole
7
19
2
Fig. 4
2
Fig. 5