OVE BEL 48 831555 Mode D'emploi page 11

1. Slide the 2 stoppers (E) and the 2 support bar's anchors (D) onto the support bar (F).
2. Loosely mount the support bar (F) onto fixed glass panel (C) using the brackets (G) and level it.
3. Mark the outline of the 2 support bar's anchors (D) on the wall.
4-6. Completely remove the support bar. Place the 2 support bar's anchors (D) back on their wall mark, then mark
their center on the wall.
Note: Before continuing, place the door panel (J) inside the shower enclosure to facilitate future steps!
7. Drill a hole on the center marks and insert the wall anchors (AA) using a rubber mallet.
8. Fix the center fitting of the support bar's anchors (D) using the screws (GG).
9 Slide again the roller stoppers (E) and the support bar's anchors (D) onto the support bar (F). Then fix the support
bar to the wall.
10. Fix the fixed panel (C) onto the support bar (F) using the brackets (G).
11. Secure the support bar (F) on their anchors using the provided hex screws. Install the aluminum profile (K)
between the roller stopper and support bar's anchors.
8
AA
SUPPORT BAR INSTALLATION
D
E
D
D
GG
E
1
F
C
9
F
C
11
2
G
F
4
6
D
10
G
F
3
D
5
7
Φ8mm
5/16in
11
K
F