EINHELL Bavaria BKP 100 Mode D'emploi page 5

Anleitung BKP 100 12.12.2001
Putting into operation
Fix the clip-rest onto the front of
the hot glue gun. Fold the clip
forwards so that it locks securely
into place in the foremost setting
before inserting the power plug
into the power outlet.
Always put the hot glue gun down
on a non-flammable surface.
Push a glue cartridge into the hot
glue gun as far as the limit stop.
Now insert the power plug into the
power outlet. The glue gun will
be ready for use after a warm-up
time of approx. 5 minutes.
Squeeze the trigger to apply the
glue in drops or strips depending
on which nozzle is used.
Press both surfaces together
immediately. The adhesion time
is approx. 30 seconds.
During interruptions and upon
completing the work, always use
the clip-rest to support the hot
glue gun.
Warnings
Disconnect the power plug
when the device is not in use.
Keep the device away from
children.
Do not let the device come
into contact with water.
The hot nozzle and the hot
glue can cause burns.
If you are going to stop work
for more than 30 minutes, dis-
connect the gun from the
power supply.
Keep inflammable and ignita-
ble materials and objects
away from the hot nozzle.
In the warm-up period and
during use place the hot glue
gun on a non-flammable sur-
face.
Avoid contact with the skin,
water and materials contai-
ning solvents.
Caution!
Glue stains on textiles cannot be
removed
10:56 Uhr Seite 5
GB
Important!
If the power cable is damaged it
must be replaced by the manufac-
turer, by the manufacturer's
Customer Service or by a similar-
ly qualified person in order to
avoid danger.
Technical data
Power supply 110-240 V ~ 50 Hz
Power input 15 (50) W
Heat-up time approx. 5 mins
Melting point approx. 140°C
Working temperature approx.
170°C
Glue stick Ø 11 mm
5