Set-Up - Renkforce MT-88WEC Mode D'emploi

8. Set-Up

When selecting the set-up location, please take into consideration the room layout such as the whereabouts of the
nearest socket, etc.
When selecting the set-up site, observe that direct sunlight, vibration, dust, heat, cold and moisture must be avoided.
There also must not be any strong transformers in the device's proximity.
Only operate the device on a stable, horizontal surface. There must be enough air circulation to permit
dissipation of the generated heat. Therefore, only place the device on level surfaces and not on carpets,
etc. Do not cover the ventilation openings in the housing. Non-observance of this note may cause damage
to the device.
When setting up the device, make sure that the connection cables are neither pinched nor damaged by
sharp edges.
Always place cables so that no one can trip over them or be caught in them. There is a danger of injury.
Only operate the turntable in a horizontal position, otherwise it will not function properly. If this note is not
observed, records or the turntable may be damaged.
Make sure you position the device safely. Falling devices may pose a significant risk of accident.
Due to the diversity of furniture paints and polishes used, it is possible that the device's feet will leave vis-
ible residue on furniture due to chemical reaction.
The device therefore should not be placed on valuable furniture surfaces without any suitable protection.
• Put your turntable on a stable and horizontal surface.
• Set up the turntable at a sufficient distance from any speakers to avoid acoustic feedback.
• The area of set-up should be uncoupled from the ground.
30