ETOE A1172 Mode D'emploi page 8

Placement
① Place the projector right towards the projection surface to get a
rectangle picture.
② The distance between the projector and the projection surface
determines the picture size.
③ Check the projection distance and screen size on the specifications part.
Prepare the Remote Control
Install the remote control batteries (batteries not
included).
① Press and open the battery cover, as illustrated.
② Install two AAA batteries. Make sure that the
positive and negative ends are positioned
correctly, as illustrated.
③ Place the battery cover back until it clicks
into place.
Power On
2
① Connect the AC cord to the adapter, Plug the adapter into the outlet
② Connect the included adapter to the DC-in port of the projector, and the
LED indicator will be on red light.
③ Set the projector towards a suitable projection screen or wall.
④ After plugging on the power, wait for 3-4 seconds, and then press the
power button. The LED indicator will turn green.
Focus
① Place the projector towards a suitable projection surface or wall, adjust
the distance for a proper size of picture.
② Scroll the [Focus Adjusting Knob] left or right until the picture is crystal
clear.
Get started
3
1
06
DC IN
EN