Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY OF THE JUICER
• Remove the juicer from its packaging.
• Check to make sure the juicer and/or assembly parts are not
damaged. If such is the case, do not use the appliance and return it
to the place where it was purchased.
• Completely unwind the mains cord.
• Place the drive on a stable surface that can be easily cleaned.
• Position the juice contain on the drive base. Make sure that the
arrows on the container coincide with those on the drive base as
shown below.
• Then position the pulp control and last of all, the cone, by pressing
lightly until you hear a click.
• If you wish to squeeze larger citric fruits, you can use a second
cone, by placing it on top of the one already in place.
• Last of all, select the required level of pulp straining, by using the
pulp control, 1 being the lowest straining level and 5, the highest
level.
• Plug the cord into the mains, in a properly installed socket.
• The juicer is now ready for use.
HOW TO USE
• Clean all the juicer parts as indicated in the section on CLEANING
before first use.
• Avoid applying too much pressure on the juicing cone. Do not
place such pressure as stops the cone from turning. The motor
could be damaged as a result.
• Let the motor run for a short period of time (max. 15 seconds).
• If you wish to squeeze large quantities, stop for a few minutes to
allow the motor to cool down. Otherwise, it could overheat.
• Keep away from sensitive objects and/or surfaces difficult to clean.
• To prepare the citrus fruits, cut them in half and place them next to
the juicer.
27
Publicité
