Publicité
Les langues disponibles
Les langues disponibles
Before You Call for Service
If the unit appears to be malfunctioning, read through this
manual first. If the problem persists, check the trouble-
shooting guide below. Locate the problem in the guide and
refer to the cause and its remedy before calling for service.
The problem may be something very simple that can be
solved without a service call. However, it may be required
to contact your dealer or a qualified service technician.
Electrocution Hazard
Never attempt to repair or perform maintenance on
the unit until the main electrical power has been
disconnected. Turning the unit control "OFF" does
not remove electrical power from the units wiring.
Problem
Unit not cold enough.
Adjust temperatures (See "Set Tem-
peratures" on page 6).
Unit too cold.
Adjust temperatures (See "Set Tem-
peratures" on page 6).
No interior light.
Light will not go out when door is
closed.
Noise or Vibration.
Unit will not run.
TROUBLESHOOTING YOUR WINE CELLAR
•
Control set too warm.
•
Content temperature not stabi-
lized.
•
Excessive usage or prolonged
door openings.
•
Airflow to front grille blocked.
•
Door gasket not sealing properly.
•
Control set too cold.
•
Door gasket not sealing properly.
•
Failed light bulb.
•
Door not activating light switch.
•
Unit not level.
•
Unit turned off.
•
Power cord not plugged in.
•
No power at outlet.
Possible Cause
15
Remedy
•
Adjust temperature colder. Al-
low 24 hours for temperature to
stabilize.
•
Allow temperature to stabilize for
at least 24 hours, with minimal
door openings.
•
Airflow must not be obstructed to
front grille. See "clearances" on
page 4.
•
Check door alignment and/or ad-
just or replace door gasket.
•
Adjust temperature warmer. (See
page 6, "set temperature"). Al-
low 24 hours for temperature to
stabilize.
•
Check door alignment and/or ad-
just or replace door gasket.
•
Replace light bulb, see page 14.
•
Verify cabinet is level, refer to
page 4 for leveling instructions.
•
Verify the door is aligned properly,
refer to page 10 for instructions.
•
Level unit, see "Leveling Legs" on
page 4.
•
Turn unit on. See "Start your Appli-
ance" on page 6.
•
Plug in power cord.
•
Check house circuit.
Publicité
