IP CLEANING FOX Manuel D'instructions page 20

 No changes or modifications to the
mechanical or electrical safety
devices shall be made.
 All repairs must be carried out by
an authorized service centre.

Use only original
original accessories
local dealer. Use of non original
filters will void the warranty.

Turn off the machine and unplug
before starting filter change, grasp
the plug, not by pulling on the
cord.
 Do not use the machine as a toy.
 Do not leave children with the
machine without supervision.
 This appliance is not intended for
use by young persons or infirm
persons without supervision unless
they have
supervised by a responsible person
to ensure that they can use the
appliance safely.
 Young
children
supervised to ensure that they do
not play with the appliance.
 If the supply cord is damaged, it
must be replaced
manufacturer or its service agent
or similarly qualified person in
order to avoid a hazard.
 ATTENTION: it is forbidden to
carry out changes
apparatus. Tampering could cause
fires and damages even lethal to
the user and the forfeiture of the
guarantee.
 The manufacturer declines any
responsibility for damages caused
to people or things due to non-
compliance with these instructions
or if the apparatus is unreasonably
used.
All manuals and user guides at all-guides.com
filters and
from your
been adequately
should be
by the
to the
3. Instructions for use
Before using the machine make sure
that the voltage shown on the rating
plate on tank corresponds with the
mains voltage.
3.1 Start and stop
Start
1. Pull out the cord (7) and plug
the machine to a wall socket.
2. Press the on/off button (5)
Stop
1. Turn off the machine (5) and
unplug.
2. Unplug by grasping the plug,
not by pulling on the cord.
3.2 Pre-filter Cleaning
The pre-filter (11) needs to be
cleaned from time to time with the
built in automatic filter cleaning
system. The pre-filter (11) needs to
be cleaned
performance
consequently motor noise increases.
Pre-filter cleaning
1. Turn the machine on.
2. Make sure that the air intake
on the hand tube is closed
3. Put the hand tube (4) into the
holder (9) and thereby closing
for the air-flow. Motor builds
up maximum under pressure
in the tank.
4. Push the filer cleaning button
(12) 4-5 times.
5. Remove the hand tube (4)
from the holder (9)
20
EN
when the suction
decreases and