Publicité
Les langues disponibles
Les langues disponibles
Encoding of Phono into MP3 file
The system is able to encode the phono to MP3 format and recording at memory media with USB connec-
ting port or SD/MMC card.
A) Phono encoding
1) Insert the USB or SD media to the main unit refer the Playback of MP3 song via USB storage media
or memory card section.
2) Set the function button to "Phono" mode and then press the "Rec" button (3) directly.
3) The LCD display will show
mode after few seconds.
4) Start playback at phono for the track which you want to record to USB.
5) After finish of recoding, press the " Rec " button (3) until the LCD stop flashing and return to "phono"
mode.
Remark:
- The recording speed is 1:1 and according to the actual playing time of the phono
- The system will create a folder and then store the encoding track in it.
- The recording format is set at – MP3 bit rate: 128 kbps, sampling rate: 44.1khz
- No song title will be recorded during encoding mode.
- If both media (USB/SD) inserted to the unit, unit defaulted record to USB media when encoding from
phono.
- Due to this unit defaulted at USB mode encode, thus, during encoding to SD card, please do not insert
the USB media, it will cause the unit had abnormal phenomenon.
B) Track separation (by remote handset)
You can divide the recording music from phono to USB/SD track by track during encoding. Every time
when press the track separation button once at remote handset during encoding from phono to USB/SD,
the system will generate a new track and continuous the recording. The text "phono" at LCD display will
flashing one time, it mean the unit is creating a new track successfully.
Removing of USB / memory card
To remove the USB / memory card, turn off the power or switch the function mode to tuner first. For
USB port – un-plug it by pulling out the USB socket directly, for memory card –pull out the SD/MMC card
straightly without bending.
noted:
- Remove the stylus protector.
- Be sure that the tone arm is being detached from the tone arm rest before opera-
ting and re-secured again afterwards.
1. Select to " Phono " function (7).
2. Set the speed selector to the proper position depending on the record to be played.
3. Place the record on the platter (use the spindle adaptor if required).
4. Lift the tone arm from the rest and slowly move it to the record side. The platter
will start to rotate.
5. Place the tone arm to the desired position of the record.
6. Adjust the volume to the desired level.
7. At the end of record, the platter will automatically stop rotating. Lift the tone arm
from the record and return it to the rest.
8. To stop manually, lift the tone arm from the record and return it to the rest.
Remark : As some kind of record the auto-stop area was out of the unit setting, so it will stop before the last rack
finish. In this case, select the auto-stop switch to " off " position, then it will run to the end of the record but will not
stop automatically (turn off the power button or switch back the auto-stop switch (34) to " on " position to stop the
platter rotate). Then put back the tone arm to the rest position.
All manuals and user guides at all-guides.com
or
&
and flashing, and the system is starting the encoding
Phono
12
12
Publicité
