Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
4.
Use of an attachment not recommended or sold by
the battery charger manufacturer may result in a risk
of fi re, electric shock, or injury to persons.
5.
To reduce risk of damage to electric plug and cord,
pull by plug when disconnecting battery charger.
6.
Make sure cord is located so that it will not be stepped
on, tripped over, or otherwise subjected to damage or
stress.
AC Input Rating Amperes*
Equal to or
greater than
0
2
3
*
If the input rating of a battery charger is given in watts
rather than in amperes, the corresponding ampere
rating is to be determined by dividing the wattage
rating by the voltage rating–for example:
1,250 watts
125 volts
8.
Do not operate battery charger with damaged cord or
plug-replace them immediately.
9.
Do not operate battery charger if it has received a
sharp blow, been dropped, or otherwise damaged in
any way; take it to a qualifi ed serviceman.
10. Do not disassemble battery charger; take it to a
qualified serviceman when service or repair is
required. Incorrect reassembly may result in a risk of
electric shock or fi re.
11. To reduce risk of electric shock, unplug charger from
receptacle before attempting any maintenance or
cleaning. Removing the battery will not reduce this
risk.
8
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS FOR BATTERY CHARGERS
but less
than
2
3
4
= 10 amperes
7.
An extension cord should not be used unless
absolutely necessary. Use of improper extension cord
could result in a risk of fi re and electric shock.
If extension cord must be used make sure:
a.
That blades of extension cord are the same
number, size, and shape as those of plug on
battery charger:
b.
That extension cord is properly wired and in good
electrical condition; and
c.
That wire size is large enough for AC ampere
rating of battery charger as specifi ed in Table 1.
Table 1
AWG Size of Cord
Length of Cord, Feet (Meter)
25 (7.5)
50 (15)
18
18
18
18
18
18
IMPORTANT SAFETY INSTRUCTIONS
FOR USE OF THE BATTERY AND
BATTERY CHARGER
You must charge the battery before you can use the power
tool. Before using the model UC18YFSL battery charger,
be sure to read all instructions and cautionary statements
on it, the battery and in this manual.
REMEMBER: USE ONLY metabo HPT BATTERY MODELS
OF THE BSL18 SERIES. OTHER MODELS OF BATTERIES
MAY BURST AND CAUSE INJURY!
Follow these instructions to avoid the risk of injury:
WARNING
1.
NEVER disassemble the battery.
2.
NEVER incinerate the battery, even if it is damaged
or is completely worn out. The battery can explode in
a fi re.
3.
NEVER short-circuit the battery.
4.
NEVER insert any objects into the battery charger's air
vents. Electric shock or damage to the battery charger
may result.
5.
NEVER charge outdoors. Keep the battery away from
direct sunlight and use only where there is low humidity
and good ventilation.
6.
NEVER charge when the temperature is below 32°F
(0°C) or above 104°F (40°C).
100 (30)
150 (45)
18
16
16
Improper use of the battery
or battery charger can lead to
serious injury. To avoid these
injuries:
16
14
14
Publicité
Table des Matières
