Grandstream Networks IPVT10 Guide D'installation Rapide page 7

CONFIGURING THE IPVT10 SERVER:
1. Please make sure that the IP address of the PC is under the same
network segment as the server's. If not, users need to go to "Network"
configuration page of the PC to setup the network segment as the same
as IPVT10 server's.
2. Enter the IP address (http://192.168.88.88) of the equipment in the
browser of the PC, and press "Enter" to access the configuration page,
as the screenshot shows below:
3. Input login user name and password (The default user name is "admin",
and the default password is "change_me").
4. (Optional) Users could select the language on the list at the bottom of the
configuration page.
5. Click to login to the configuration page.
If there is an IP conflict, users can connect the PC directly to the server via an
Ethernet cable for configuration purpose. Follow the steps below:
1. Unplug the Ethernet cable from the Ethernet Port 1 on the IPVT10
equipment.
2. Then, connect the Ethernet Port 1 and a PC with an Ethernet cable.
~ 9 ~
All manuals and user guides at all-guides.com
550W
ROHS
550W
3. Enter the IP address (http://192.168.88.88) of the equipment in the
browser of the PC, and press "Enter" to access the configuration page.
4. Input login user name and password (The default user name is "admin",
and the default password is "change_me").
5. (Optional) Users could select the language on the list at the bottom of the
configuration page.
6. Click to login to the configuration page.
Notes:
• After the configurations are complete, users must unplug the Ethernet
cable from Ethernet Port 1, and reconnect the server to the Gigabit
Ethernet switch to ensure that the two Ethernet ports of the equipment
are connected to the Gigabit Ethernet switch.
• For more information, users could go to Grandstream official website
www.grandstream.com/support and download the User Manuals of
IPVT10.
~ 10 ~