Publicité
Les langues disponibles
Les langues disponibles
Figure 6
10. On the interior flange of the housing, apply a generous amount
of caulking and install the housing through the hole and onto
the casing strips and secure in place using screws or nails
(not included) through the predrilled holes on the four corners
of the housing. Seal the flange where the housing meets the
wall with caulk (Figure 7).
Screws
Figure 7
SECTION 3
Wiring
CAUTION:
MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE STARTING INSTALLATION.
CAUTION:
ALL ELECTRICAL CONNECTIONS MUST BE
MADE IN ACCORDANCE WITH LOCAL CODES, ORDINANCES,
OR NATIONAL ELECTRICAL CODE. IF YOU ARE UNFAMILIAR
WITH METHODS OF INSTALLING ELECTRICAL WIRING, SECURE
THE SERVICES OF A QUALIFIED ELECTRICIAN.
1. Run wiring from an approved wall switch carrying the
appropriate rating. One neutral (white), one ground (green
or bare copper), and one hot (black).
2. From inside the house, insert the inner housing into the outer
housing until it is tight against the wall. Line up three holes
at the end of the inner housing with three of the holes on the
outer housing and secure in place with the three included
3/8" screws (Figure 8).
Knockouts
Figure 8
210575005 Rev. A 10-06
Knockouts
Caulk
Holes
Inner
Housing
Electrical
Opening
NOTE: If you removed any of the electrical compartment clearance
knockouts on the outer housing, make sure the electrical opening
of the inner housing is aligned with them.
3. Pull the electrical wires through the electrical opening of the
interior housing. Remove one of the electrical knockouts of
the wiring compartment and run wires through the opening
making sure to leave enough wiring to make the connection
to the fan's receptacle. Secure wires to wiring compartment
with an approved electrical connector (Figure 9).
Electrical
Opening
Figure 9
4. Connect the green or bare ground wire from the house to
the ground screw in the wire compartment. Connect the
white wire from the house to the white wire from the
receptacle. Connect the hot (black) wire from the wall switch
to the black wire from the receptacle (Figure 10). Use approved
methods for all connections.
Figure 10
5. Insert the wire compartment into the electrical opening of the
interior housing and line up holes of wire compartment and
wire compartment cover with holes on the interior housing.
Secure in place using the two included 1/2" screws (Figure 11).
Figure 11
www.airkinglimited.com
Knockouts
Wiring Compartment
Wiring Compartment
Cover
Wiring Compartment
Electrical Opening
3 of 12
Publicité
