SEYMO RT600 Mode D'emploi page 4

RT600 Alarma temperatura motor SEYMO
English
With the temperature control SEYMO © you will know in real time the
degrees centigrade to which your engine is working. You can also set a
maximum temperature value, from which the device will emit a sound
and visual alarm. Thanks to the temperature control SEYMO © will
ensure that your engine is running in optimal conditions and will avoid
prolonging any possible overheating.
Place the programmed digital display of the SEYMO © temperature
control in a visible place near the control station. Remove the back cover
of the digital display and connect the 12V power supply with a 1 amp fuse,
and the probe. The probe cable must be installed on the motor block, as
close as possible to the cylinder head. It has a perforated finish to
facilitate fixing to your motor through screws.
Take special care when guiding the rest of the cable to avoid contact
with the other hot areas of the motor.
Important do not pull the terminal (hole) to pass the cable could
damage the probe
Configuration
Push button on / off. Press once to turn on. Press and hold 3 seconds to turn off.
Has memory Will remain connected or disconnected when the power is turned on
Configuration button. Press once to change the maximum
temperature at which the alarm will be activated. When it is at the
desired value, press once to confirm or wait for 3 seconds, in both cases
the value of the alarm will be saved.
Push buttons. In the configuration mode (when you press Set),
select Up / Down to change the warning temperature value to 110C◦.
The alarm will be activated when the probe detects a temperature
at least 1C◦ higher.
WARRANTY
Our products are guaranteed against any manufacturing defect or material failure for a period of 2 YEARS from the
date of purchase.
In case of observing any defect or breakdown in the normal use of the product during the guarantee period
Contact the supplier.
It can not be applied in case of improper use, connection or incorrect handling by the buyer.
The scope of this warranty is limited to the repair of the device, the manufacturer declines any other liability that
could be claimed for incidents or damages caused by the product's malfunction.
CONFIGURACIÓN
MONITOR
FALLO SONDA ABIERTA
FALLO SONDA CORTO
ALARMA