Publicité
Les langues disponibles
Les langues disponibles
8. Install the replacement auger by following the above steps
in reverse order (Fig. 19).
Fig. 19
Replacing the Belt
m
WARNING!
Make sure to turn off the unit and remove
the battery before performing any maintenance task on your
cordless snow shovel.
1. Disassemble the left side cover by removing the
five (5) screws that hold it in place (Fig. 12).
2. To remove the old belt from the drive wheel, use one hand
to slowly turn the auger while use the other hand to lift the
belt (Fig. 20).
Fig. 20
3. Replace a new belt in place. Place the left side cover back
into position and refasten the five (5) screws.
Replacing the Scraper Bar
m
WARNING!
Make sure to turn off the unit and remove
the battery before performing any maintenance task on your
cordless snow shovel.
All manuals and user guides at all-guides.com
1. Turn the snow shovel over. Using a drill, remove the
2. Remove the old scraper bar (Fig. 22).
3. Install the new scraper bar and fasten it securely to the
Drive
wheel
Belt
Auger
Lubricating the Cordless Snow Shovel
This cordless snow shovel does not need lubrication. All
bearings are lubricated at the factory for the life of the product.
Storage
1. Examine the cordless snow shovel thoroughly for worn,
13
four (4) screws that secure the scraper bar to the base of
the unit (Fig. 21).
Fig. 21
Remove
the screws
Fig. 22
Scraper bar
housing with the four (4) screws (Fig. 23).
Fig. 23
Fix with
the screws
loose or damaged parts. Should you need to repair or
replace a part, contact an authorized Snow Joe
Sun Joe
dealer or call the Snow Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563) for assistance.
+
®
+ Sun Joe
®
®
Publicité
