SNOWJOE 24V-SS13-XR Mode D'emploi page 12

2. Remove the belt from the drive wheel (Fig. 13).
Fig. 13
3. Remove the screws, the washers, and the bushings from
the drive wheel (Fig. 14).
Fig. 14
Bushing
4. Disassemble the right side cover by removing the five (5)
screws that hold it in place (Fig. 15).
Fig. 15
Right side cover
All manuals and user guides at all-guides.com
5. Use one hand to secure the auger, at the same time, use
Belt
Drive wheel
6. From the left side, remove the auger axle set (Fig. 17).
Washer Screw
7. Remove the old auger from the housing (Fig. 18).
12
the other hand to remove the auger assembly nut on the
right side. (Fig. 16).
Fig. 16
Auger
assembly nut
Fig. 17
Fig. 18
Auger axle set
Auger