Sunforce 82183 Assemblage Et Installation page 2

!
cautions: safety information
• Your motion light is not a toy. Keep it out of reach of small children.
• Your motion light and solar panel are both weather-resistant.
• You can mount your motion light indoors, but your solar panel must be installed outdoors to receive light from
the sun.
• If using a step ladder, you may require a second person to help install the solar motion light.
• Prior to installation, lay out all components to ensure they correspond to the parts diagram on the cover page.
• Never look directly into the solar motion light when illuminated.
!
cautions: Battery instructions
• Use rechargeable batteries only.
• Always purchase the correct size and grade of battery most suitable for the intended use: for optimal
performance use 3 AA Ni-MH 1800 mAh 1.2V rechargeable batteries. If this battery is not available locally,
any 1.2V rechargeable AA battery will be adequate for the light to operate.
• Always replace the whole set of batteries at one time, taking care not to mix old and new ones, or batteries
of different types.
• Clean the battery contacts and also those of the device prior to battery installation.
• Ensure the batteries are installed correctly with regard to polarity (+ and -).
• Remove batteries from equipment which is not to be used for an extended period of time.
• Remove used batteries promptly.
For recycling and disposal of batteries to protect the environment, please check the internet or your local
phone directory for local recycling centres and / or follow local government regulations.
For more information on battery housing and location, refer to Step 9 on page 3.
care & maintenance
• From time to time, ensure the plug between the solar panel and light is securely connected.
• It is advisable to adjust the angle of the solar panel to optimize the exposure of the sun during the winter
months.
• The solar panel should be cleaned with a damp cotton cloth on a regular basis. This will ensure optimal
performance and battery charging. Periodically, utilize the same technique to clean the lenses of the
motion lights.
• Never let any abrasive material come into contact with the solar panel.
product features
• 60 LEDs per lamp head • Adjustable time and distance settings
• Adjustable motion sensor • Solar panel with 4.5 m / 15 ft wire
2
All manuals and user guides at all-guides.com
4.4 cm / 1.7 in
installation
1
2
mounting BracKet template instructions
1. Cut out the template or use the provided insert.
2. Mark the screw hole locations ( X ) using a pencil or drill.
3. Drill holes in the marked locations.
Ensure your solar panel is placed so that
1 its exposure to the sun is optimized. Be
aware of objects such as trees or property
overhangs that may impede the panel's
ability to generate a charge.
Optional: Use a power drill (not included) to
2
create the holes on your chosen mounting
surface.
Use 4 of the included wall plugs and screws
to fasten the solar panel to the surface.
Place the mounting bracket template (refer
to template shown below or use provided
insert) over the desired mounting surface.
3
Mark the screw hole locations indicated by
the symbol.
Use a power drill (not included) to drill the
holes on your chosen mounting surface.
Insert the two remaining screws and wall
plugs into the surface, leaving 3.2 mm
4
(1/8 in) of space between the screw heads
and the wall. Place the motion light's
mounting bracket onto the screw heads (1).
Lock the bracket into place by shifting it
5
horizontally (2).