Traxon Allegro Dot M Instructions De Montage

This lighting chain can use for indoor and outdoor.
Direct View
52mm/2"
Diffused View
52mm/2"
Mounting the Allegro Dot M/L
(M3 Screws not included)
(Cable ties not included)
Suggested alternative method
if M3 screws are not viable
CAUTION:
1. Always use the housing unit for mounting. Handle string with
care. Improper handling of lead cable and string will cause
damage.
2. Warning-This lighting chain must not be used without all
gaskets being in place.
www.traxon-ecue.com
Mounting Guide
A llegro Do t M/L
Mounting Guide
Distributor Box
68mm/2.7"
Ø6.3mm/0.25" x 4
Cable length:
300mm/11.8"
Smart Junction
33mm/1.3"
42mm/1.7"
25mm/0.98"
51mm/2"
Mounting the LED Engine and Pixel Distributor
LED Engine mounts
on top of the Pixel Distributor
(LED Engine is ordered
separately)
Mount Pixel Distributor
with connectors facing down
This class III lighting chains delivered without a supply source, please select the suitable power source.
Independent, constant voltage type, SELV DC 30 V output, the output power shall be not less than the
lighting chain's power, short-circuited proof, IP67 or above (if the IP rating is below IP67, the luminaire
manufacturer shall provide adequate instructions for connection to the supply ensuring an equivalent
degree of protection against harmful ingress of dust and moisture as that provided by the luminaire, for
example, the PSU use indoors), which is/are EN/IEC 61347-1 and EN/IEC 61347-2-13 certified.
09/23 V1.6
Cable length: 300mm/11.8"
204mm/8"
224mm/8.8"
244.2mm/9.6"
M4 x 4
CAUTION:
1. The light source of this luminaire
is not replaceable; when the light
source reaches its end of life the
whole luminaire shall be replaced.
2. The length of the cable between
the pixel distributor and the first
lamp or lamp holder shall not be
less than 1.5m.
3. Do not connect the chain to the
supply while it is in the packing.
M4 × 8mm × 4
(Included)
©2023 TRAXON TECHNOLOGIES. ALL RIGHTS RESERVED.
M5 anchor bolts
(Not included)
1 of 3