Publicité
Les langues disponibles
Les langues disponibles
WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS
Warm
& Serve
Drawer
Installation
Important Notes to the Installer
|]. Locate the 2 anti-tip brackets supplied as shown
in
|.
Read all instructions contained in these installation
instructions before installing appliance.
2.
Remove all packing material from appliance before
connecting the electrical supply.
3.
Observe all governing codes and ordinances.
4.
Be sure to leave
these
instructions
with the
consumer.
important Note to the Consumer
Keep these instructions for future reference.
IMPORTANT SAFETY
INSTRUCTIONS
¢ Be sure your appliance is installed and plugged
into a 120 Volt grounded outlet.
¢ This appliance must be electrically grounded in
accordance with the National Electrical Code
ANSI/NFPA No. 70—latest edition in the United
States, or CSA C22.1, Part 1 in Canada,
and local
code requirements.
Tools You Will Need
Phillips® Screwdriver,
Pencil
Ruler or Tape Measure and Straight-edge
Hand Saw or Saber Saw
Spirit Level
figure 1.
ge [625 F/i6"
24" (64.3 em) Max.
a
ae
ke
23 °/2" (60 cm) Min.
°fe12 7/32" we
(32.15 cm) ~~
™4
Figure 1
2.Slide drawer into cutout opening until front frame of
drawer is flush against cabinet. Be careful not to pinch
electrical cord.
3.Remove the drawer as instructed in the Use & Care
Guide and secure drawer housing to cabinet using the
3 nickel-plated screws supplied (see Figure 2). Do not
overtighten screws.
4.The 60" (152 cm) appliance power cord can now be
connected into the 120 Volt outlet.
5.Proceed with mounting built-in oven above the
drawer (if applicable). Follow installation instructions
provided with built-in oven. Make sure to use anti-tip
brackets supplied with the built-in oven.
Use screws
supplied to attach
-
drawer to front of
.
cabinet.
Figure 2
Publicité
