Smith 27635 Instructions D'assemblage Et De Montage

For maximum benefit when loading your boat, mount the posts as far back on the trailer frame and as close to the boat as
possible. The widest place on each boat is different. Most Jon boats are widest at the transom, while many V-hulls are widest near
the middle. Post guide-ons are most effective when mounted as close to the boat as possible while still allowing the widest point
of the boat to pass between the posts.
Tools: Two 9/16" Wrenches
27635 Parts List :
(1) Corner Bracket Kit (11505)
(2) 23" Pre-Galvanzied Tube (27607PG)
(2) 38" Pre-Galvanzied Tube (27621PG)
(2) 62-1/2" PVC Posts (11341)
(4) Brackets (27681G)
(2) PVC Cap (11393)
(2) Bolt 3/8" x 1-1/2" (11023)
(2) Bolt 3/8" x 2-3/4" (11044)
(4) Washers (10960)
(2) Locknut (10810)
1- Assemble pre-galvanized uprights using the instructions
included in the corner bracket kit (11505)
2- Determine which length bolts to use
• Two long and two short bolts are provided
• Lay one upright across your I-beam
• Straddle a pair of I-beam brackets over the upright as shown
• Hook both brackets fully under the I-beam frame
• Pinch the top of the two brackets together
• Select the bolt length that spans your I-beam and passes
through both brackets far enough to install the nut/washers
and tighten
3- Choose a mounting location.
• Brackets may be mounted above or below the I-beam
• It is best to mount as far back on the trailer as possible
• For more rigidity, mount as close as possible to a frame
cross member
4- Loosely assemble the uprights and brackets to your trailer
frame.
5- Slide PVC posts down over the uprights.
• Engage the no-rotate notch with the lance in the upright
6- Adjust the uprights to fit your boat.
• Less that 1" of offset from the boat is typical
7- Tighten the bolts. Post spacing will change during tightening.
Re-adjust and re-tighten as needed.
8- Push caps down firmly onto your guide-on posts.
C.E. Smith Company, Inc. Greensboro, NC | cesmith.com | P/N 00827 Revised 01/10/2023
Assembly & Mounting Instructions:
Post Guide-Ons for I-Beam Frames
Model: 27635