Messoa NDR891H Guide De Démarrage Rapide page 7

Drilling the Mounting Surface
1.
2.
Mounting the Camera
Use the machine screws to secure the camera base to the surface (this figure take
the tapping type screws as the example to illustrate the mounting).
Caution Tip Note
1.
2.
3.
All manuals and user guides at all-guides.com
Post the "Guide Pattern" sticker on the mounting surface.
Aiming the circles (the figure below marked with "+" ) on the sticker, drill
three screw holes and one cable entry hole in the ceiling/wall.
Guide Pattern Sticker
Camera Base
While you are securing the camera with the accompanying screws, please be
advised to hold the camera by its base. Do not hold the lens or lens base with
force that may deform the lens.
Use the machine type screws if you are attaching the camera to a pendent
mounting. Use the tapping type screws for all other surfaces.
For cement surfaces, insert the "Plastic Anchors" into the holes. For softer
surfaces, do not use the "Plastic Anchors".
+
+
+
+
Tapping Type Screw
NDR891(H)/NDR891E(H)
Plastic Anchor
l Quick Start Guide 5