Costway EP25439 Mode D'emploi page 5

Adjusting temperature
♦Use the © button (F) and ㊀ button (H) to set the thermostat to the
desired temperature between 45 °F and 99 °F.
♦After setting the temperature, the display (C) shows a blinking set
temperature and then reverts back to the room temperature.
Timer function
♦Press button (E) to set a timer. The appliance switches off automat-
ically once the set timer has passed.
♦Use the button (F) and ㊀ button (H) to set the timer from 1 hour to
24 hours. The display (C) shows a blinking set time (01H to 24H)
and then reverts back to the room temperature.
♦When timer function is activated, H indicator shows on the display
(C). To cancel the timer, press (k) button (E) and press ㊀ button (H)
to set to UH. H indicator disappears from the display (C).
Swing function
♦Press button (D) to activate or deactivate the swing function.
♦To distribute the airflow over a larger area, press button (D) and the
appliance oscillates right and left.
♦To stop the oscillation in the desired position, press button (D)
again.
Overheat protection
When parts of the appliance get excessively hot, the appliance
switches off automatically to prevent overheating.
♦To completely switch the appliance off
1.Set the power switch (M) to O position.
2.Disconnect the power plug (N) from the socket outlet.
♦To resume operation
1.Allow the appliance to cool down.
2.Wipe any accumulated dust off the air outlet grille (K) or air vent
cover (L) on the rear of the appliance.
3.Connect the power plug (N) to a socket outlet.
4.Set the power switch (M) to I position.
5.Press O button (G) to switch the appliance on.
08
Tip-over protection
♦If the appliance tips over, it switches off automatically. To resume
operation, position the appliance in upright position and press button
(G). The appliance operates in the last stored setting.
Cleaning and Maintenance
♦To clean the appliance, wipe with a soft,
slightly damp cloth.
♦Wipe any accumulated dust off the air
outlet grille (K), or air vent cover (L) on the
rear of the appliance. Use a soft brush or
brush attachment on household vacuum
cleaner if needed.
♦Remove the air vent cover (L) (Fig. 3).
Clean it in warm soapy water. Scrub with a
sponge or soft brush if needed. Refit the
air vent cover (L) after it is completely dry.
♦Wipe the appliance dry after cleaning.
♦Never use corrosive detergents, wire brushes, abrasive scourers,
metal or sharp utensils to clean the appliance.
Frequently Asked Questions
Problem
The appliance does not Check if the plug is connected to the socket outlet. Use voltage
switch on. tester to verify if the socket outlet is powered. Use appliance has
overheated. Allow the appliance to cool down and wipe any
accumulated dust off the air outlet grille (K) or air vent cover (L)
on the rear of the appliance.
The appliance is not Set to high power mode and set the thermostat to a higher
producing a sufficient temperature setting.
amount of heat. Close all doors and windows to trap heat in the room.
Use the swing function to allow the appliance to fully circulate
heat throughout the room.
The appliance is Room temperature has reached the set thermostat temperature.
powered on but there is To further increase the room temperature, set the thermostat to
no heat. a higher temperature setting.
The time set on the timer has elapsed. Press button (G) to start
operating again.
If the appliance recently had a bad fall, switch off and unplug the
appliance. Have it checked by a professional repair center.
The appliance emits Keep electrical cords, drapery, and other furnishings at Least 3
burning smell. feet (0.9 m) away from the front of the appliance and away
Solution
09