Publicité
Les langues disponibles
Les langues disponibles
A
Control panel
B
Handle
C
Display
D
button (swing function)
E
button (timer function)
F
button (increase input value)
G
button (on/off)
H
button (decrease input value)
Remote Control
NOTICE
Always insert batteries correctly with
regard to polarity (+ and -) marked on
the battery and the remote control (P].
1，Slide the cover of the battery
compartment on the underside of the
remote control (P) open (Fig. 1).
2. Insert 2 batteries (Type AAA, 1.5 V).
Make sure the polarity (+ and-) is correct
3. Refit the battery compartment cover.
NOTICE
The buttons on the remote control (P)
can be used to perform the same
functions as the button on the control
panel (A) (Fig. 2).
Control
Function
button (G)
On/off
button (J)
Mode selection
button (I)
Temperature setting
button (F)
Adjust temperature/
button (H)
timer
button (E)
Timer function
button (D)
Swing function
06
I
button (temperature setting)
J
button (mode selection)
K
Air outlet grille
L
Air vent cover
M
Power switch
N
Supply cord with power plug
O
Base
P
Remote control
Switching on/off
WARNING Risk of electric shock
♦Always set the power switch (M) to O position before connecting
the power plug (N) to a socket outlet.
WARNING High temperature
♦Keep electrical cords, drapery, and other furnishings at least 3 feet
(0.9 m) away from the front of the appliance and away from the side
and rear.
NOTICE
♦Place the appliance on a flat, stable surface. Make sure the base
(O) of the appliance is stabilized.
♦When positioning the appliance, use the handle (B) to lift and carry
the appliance.
♦The appliance can be controlled by using the buttons on the control
panel (A) or by using the remote control (P).
♦The appliance emits a beep to confirm reception each time a
button on either the control panel (A) or the remote control (P) is
pressed.
♦The indicators on the control panel (A) show the current setting.
1.Connect the power plug (N) to a suitable socket outlet.
2.Set the power switch (K) to I position. The appliance emits a beep.
3.Press O button (G) to switch the appliance on. The display (C)
shows the room temperature and the appliance starts operating.
NOTICE
When switching on after previous use, the appliance reverts to the
settings from the previous use. The corresponding indicators on the
control panel (A) light up.
4.After use, press the button (G) to switch the appliance off. The
appliance emits a beep.
When the appliance is switching off, it automatically enters a cool
down routine. The fan keeps running for about 30 seconds to
exhaust remaining heat.
5.Set the power switch (M) to O position. Unplug the appliance from
the socket outlet.
6.When room temperature reaches the set temperature, the appli-
ance stops heating up and the fan switches off after 30 seconds.
When room temperature is lower than the set temperature, the
appliance resumes heating.
07
Publicité
