Franke FGC 906 I Mode D'emploi Et Installation page 11

• Connect the Hood to the Mains power
supply, inserting a two-pole Switch with a
contact aperture of at least 3 mm.
• Remove the Metal grease filters (see par.
on "Maintenance") and make sure that the
power supply Cable is properly inserted in
the Suction fan socket.
• Take the wires indicated in fig.1 and pass
them through the slot formed on the
galvanized diffuser support, as shown in
fig.2.
• Position the finishing plug 27 over the
housing in the diffuser support, fixing it
using a screw 12e (2.9 x 9.5) and applying
the 2 cable clamp elements 26 as indicated
in figs. 3 and 4.
• Connect the Controls Connector fig. 5.
• Connect the Lighting Connector fig. 6.
• Store both the Connectors in the Protective
box 24 and close it with 2 Screws 12e (2.9
x 9.5), provided.
• Remove the protective film from the
double-sided adhesive on the connection
box, and fix
compartment fig. 7.
EN
ELECTRICAL CONNECTION
it inside the motor
2
4
6
7
1
3
5
1
11
1