Tintometer Lovibond MD 110 AL 110 Mode D'emploi page 47

Operating messages – Error codes
GB
Hı
Lo
btLo
Store Date
Cal
RESULT
Time Cal
E27 / E28 / E29
E 10 / E 11
E 20 / E 21
E23 / E24 / E25
E 22
E 70
E 71
E 72
E 73
E 74
E 75
E 76
E 77
E 78
E 79
Copyright and Trademark Notice
The Bluetooth word mark is a registered trademark owned by Bluetooth SIG, Inc. and any
®
use by The Tintometer
iOS is a registered trademark of Cisco, Inc. and licensed to Apple, Inc.
®
iTunes Store is a trademark of Apple, Inc., registered in the U.S. and other countries.
®
Android ™ and Google Play
Excel is a trademark of Microsoft Corp., registered in the U.S. and other countries.
®
MD110_3a 03/2020
Operating messages
Measuring range exceeded or excessive turbidity.
Result below the lowest limit of the measuring range.
Replace batteries, no further tests possible.
Battery capacity is too low for the display backlight;
measurement is still possible.
A user calibrated method is indicated by an arrow while the test result
is displayed (see "Factory calibration reset").
Error codes
Light absorption too great. Reasons: e.g. dirty optics.
Calibration factor "out of range"
Too much light reaching the detector.
Too much light reaching the detector.
Battery capacity was too low during measurement. Change battery.
CL 6: Factory calibration incorrect / erased
CL 6: User calibration incorrect / erased
CL 10: Factory calibration incorrect / erased
CL 10: User calibration incorrect / erased
pH: Factory calibration incorrect / erased
pH: User calibration incorrect / erased
CyA: Factory calibration incorrect / erased
CyA: User calibration incorrect / erased
tA: Factory calibration incorrect / erased
tA: User calibration incorrect / erased
Group is under license.
®
™ are trademark of Google, Inc.
47