Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE AND CLEANING
LIGHT BULBS
Warning: Make sure that the lights have been switched off for some time
and that the power source has been disconnected before replacing
the bulbs that remain hot a long time after having been turned off.
1. To open, turn counter clockwise.
2. Remove the bulb.
3. Insert a new bulb (GU10).
4. Close by turning clockwise.
SURFACE MAINTENANCE
Clean periodically with hot soapy water and a clean cotton cloth. Do not
use corrosive or abrasive detergent (e.g. scouring powder, oven cleaner,
steel wool or scouring pad) which will scratch and damage the surface.
For heavier soil, use liquid degreaser. After cleaning, you may use a non
abrasive stainless steel polish to polish and bring back the shine. Always
scrub lightly, with a clean cotton cloth and with the steel polishing grain.
ALUMINUM FILTERS
The filters installed at the factory are intended to filter out residue and
grease from cooking. They do not need to be replaced regularly but must
be cleaned.
Filters should be cleaned after about 30 hours of use.
Remove and clean by hand in hot soapy water or in the dishwasher.
For heavy soil, use a degreasing detergent and leave to soak.
Dry filters and reinstall it before using the hood.
Replace used or damaged filters.
* Caution: Never install unless you are in possession of the product. Measurements may vary as a result of improvements made to the product over
time. Neither the manufacturer nor the distributor shall be liable for variances between the measurements shown here and the product's actual
measurements. This product should be installed by a certified professionnal, in accordance with the regulation in effect.
5
ADVICE FOR HOOD CLEANING
▪
Generally, hot soapy water is enough.
▪
Rinse with clear water, wipe dry with a clean, soft cloth to avoid
water marks.
▪
For discolorations or deposits that persist, use a non-scratching
household cleaner or a stainless steel polishing powder with a little
amount of water and a soft cloth.
▪
For stubborn stain, use a plastic scouring pad or soft bristle brush
together with cleaner and water. Rub lightly in the direction of the
polishing lines or "grain" of the stainless finish. Avoid using too much
pressure that may mar the surface.
▪
Do not allow deposits to remain for long periods of time.
▪
Do not use ordinary steel wool or steel brushes. Small bits of steel may
adhere to the surface thus causing rust.
▪
Do not leave salty solutions, disinfectants, bleaches or cleaning
compounds to remain in contact with the stainless steel for extended
periods. Many of these compounds contain chemicals that may be
harmful. Rinse with water after exposure and wipe dry with a clean cloth.
Publicité
