Clean Air Optima CA-703B Manuel page 6

How to use
Power
Press the "POWER" button, the button lights
up blue, the device starts to dehumidify.
Press the "POWER" button again, the device
turns off. All indicator lights go out. The fan will stop
10 seconds later.
The evaporator in the dehumidifier may defrost
automatically if it is operated with a room temperature
less than 18 °C.
- During the defrosting operation, the dehumidification
function and air purification function may intermit.
- Don't turn of the power or pull out the power plug of
the device during the defrosting operation.
Air Purify Indicator Light
When the device is working, the air purify
function (Ionizer & UV) starts to work when
you push this button. The indicator light will
light up.
Timer
Press the "TIMER" button to set 0-24 hours
timing. Press the button one time, the timer
will increase with one hour.
When the device is operating, the timer that is set
indicates when the device switches off.
Temperature Light
This light shows the indoor temperature. This light shows the temperature both
when the device is in operation and in standby mode.
Dehumidify Indicator Light
This light shows the indoor humidity. This light
shows the humidity level both when the device
is in operation and in standby mode.
Water Tank Full Indicator Light
When water tank is full, the device will automatically stop. This light turns on and
lights up red.
Drain the water tank, and return the water tank to the body of the device, the water
tank full indicator light will turn off. The device will work automatically again.
6