Technical Specifications; Packing List - Metal Works UCL010 Mode D'emploi

UCL - NLFRENES - v1.0 - 15102013
EN

Technical specifications

Model
Capacity
Ultrasonic power
Heating power
Total power
Inner chamber size
Frequency
Adjustable temperature ~ 80°C
Adjustable time
Drainage
Basket
Lower-noise cover

Packing list

1 Cleaning machine
1 Operation manual
1 Q.C. Pass
1 Basket
1 Power line
Note: No drainage and drainage pipe for under 5l
Note: The technology and specifications can be altered by us without notice.
Instructions for use
1. Check the grounding wire of the ultrasonic cleaning machine and power line is in good condition
(electricity leaking exists or not).
2. The cleaning solution can be put into the cleaning slot. When cleaning, level of the solution can't be below
one third of the height of the cleaning slot, above two thirds of the cleaning slot. You should add different
detergents according to different cleaning requirements, thus to increase cleaning efficiency. All detergents
should not fret the inferior slot and the body of the cleaning machine.
3. Insert the plug of the ultrasonic cleaning machine into the power socket of 220-240VAC - 100-120VAC.
Rotate the switch of the timing controller and the indicator will be on. When the surface of the solution
fluctuates like a spider web with noise, it means that the cleaning machine is working.
4. According to the cleaning requirement, set the cleaning temperature.
5. Put things to be washed into the metal frame, and set the cleaning time according to the real situation
of fouling accumulation. Normally the time
prolonged for things which are especially difficult to be cleaned.
6. For heavy articles, suspend it through a hanger in the cleaning solution to increase the cleaning effect,
heighten the cleaning quality.
7. Take the article to be washed out; rewash or rinse with the ultrasonic machine.
8. If you don't use the machine for a long time, you should drain the cleaning solution in the slot out, and
clean the body of the machine.
UCL 010
10 l
240 W
285 W
525 W
300 x 240 x 150 mm 500 x 300 x 150 mm 500 x 400 x 300 mm
40 kHz
1 ~ 99 min
Yes
Yes
Yes
can be set between 3-30 minutes, and the time can be
UCL 022
22 l
500 W
475 W
975 W
40 kHz
~ 80°C
1 ~ 99 min
Yes
Yes
Yes
UCL 060
60 l
1000 W
1500 W
2500 W
28 kHz
~ 80°C
1 ~ 99 min
Yes
Yes
Yes
®
9