Publicité
Les langues disponibles
Les langues disponibles
Frequently check rotor blades to make sure they are in good working condition
and properly secured to the rotor. Replace worn or damaged parts with new
blades.
IMPORTANT:
Make sure that the replacement of blade with other same weight. This will be a
balance of rotor spinning.
IMPORTANT:
The replaced blade must be the original factory accessories.
The blade has a cutting edge on both the leading and trailing edges. When the
leading edge wears out, turn existing pair of blades around 180 degrees and
reinstall. Replaced blade should be the same length as existing part to maintain
rotor balance.
Blades replacement
1. Remove locknut (#1), bolt (#3) for forged hammer system.
2. Remove existing blades or turn existing pair of blades around 180 degrees and
reinstall.
3. Install blade with existing bolt, washers, and locknut.
4. Tighten locknut with correct torque.
Publicité
