Publicité
Les langues disponibles
Les langues disponibles
Installation
If replacing an older faucet
ensure water supply is turned
OFF before removing, then
turn faucet control valve ON to
relieve water pressure.
DO NOT use pipe dope
or thread sealant on drain
assembly, or any plastic
threaded components.
1) Insert faucet body (G) through
mounting gasket (I) and sink
holes.
G
I
2) Install mounting nuts (J) onto
1/2" IPS inlet connections on
faucet body (G). Using a wrench,
finish with one-half turn. DO NOT
overtighten.
1
1
1
3) Push Pop Install: Insert drain
body (L) into drain opening. From
below, Tighten locking nut (O)
with gasket (M) and washer (N)
to flange. Tighten tail nut (Y) with
washer (X) to secure tail pipe (Q).
DO NOT overtighten.
Plumbers Putty
4) Attach supply lines to 1/2" IPS inlet
connections on faucet body (G).
Using a wrench, finish with one half
turn. DO NOT overtighten.
G
J
L
1
M
N
2
O
X
3
Q
Y
G
3
5) Attach supply lines to shut-off
valves and hand tighten. Using a
wrench, finish with one-half turn.
DO NOT overtighten.
1
1
6) Remove aerator (H) and flush
lines free of debris. Check for
leaks.
2
H
Publicité
