Publicité
Les langues disponibles
Les langues disponibles
Setting Up Your Table
Steps are as below:
1
2
5
6
1. Release the buckle.
2. Lay the table on its side with four rubber feet on the floor, open up the table
with four legs extending as full as possible.
3. Take out all accessories.
4. Lift the table up until all legs are on the floor.
5. Put accessories into the corresponding outlets.
6. Release the side knob of the headrest cradle, and then press and fix it once
the headrest is adjusted to the required position.
7. Now the table is ready for your use.
Re: The height of the table is adjustable. Turn off the knobs, take out the
movable leg to adjust the height by choosing the holes on the movable leg,
and put back onto the leg and then fasten the knobs firmly. Four legs should
be done in the same way one by one and make sure all legs are adjusted into
the same height level.
04
3
4
7
Disassemble and store the table
1. Lift up the backrest to the max and put down the backrest, lock the buckle.
2. Take out all accessories.
3. Lay the table flat with four rubber feet on the ground.
4. Put all accessories under the elastic strap under the top veneer.
5. Fold the legs on each end at angle inwards by pressing the corresponding
support arms.
6. Fold the table up and lock the buckle.
7. Carry the table like suitcase by grasping the handle.
Warning: If the frame/legs/table structure is damaged in anyway, you should
not use this table.
Using this table when damaged may cause harm or serious injury to you or
your patient. You should seek repair immediately.
05
Publicité
