Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTIONS FOR CABLE HEIGHT
In order to assemble the zip wire correctly and safely, the following height requirements
need to be followed. One end of the cable must be mounted at a higher level than the other
end. These heights are dependant on the height of the user and the distance between the
fixing points. In order to determine the right heights, the following steps must be followed;
1. Measure the height of the user. If there is more than one user, and the difference in
height is less than 15 cm, use the height of the tallest user. If the difference is more than
15 cm, the zip wire needs to be adjusted every time the user's height is outside the
specified range.
2. Add 75 cm to the measured height of the user and mark this point on the tree or
construction frame.
3. Measure the distance between the 2 fixing points. Determine the corresponding height in
the following table and mark this height on the tree / construction at the other side.
height lowest
height
fixing point(x)
user
WARNING! Only for domestic use. Not suitable for children under 3 years.
To be used under the direct supervision of an adult. Long cord, risk for strangulation! Risk
of falling!
height highest fixing point according to the following distances between
the 2 fixing points (y)
3
Publicité
