Krüger & Matz TT-501 Mode D'emploi page 13

Owner's manual
Warning: Incorrect platter setup can lead to poor turntable performance, platter instability or
permanent motor damage.
1. The rubber belt has been pre-installed onto the turntable platter. However, please turn
the platter over and make sure that the belt is attached and is not twisted. If the belt has
come off during shipping, please place it around the inner bottom ring of the turntable
platter, as shown above (no. 1).
2. Place the platter on the center spindle and press it down firmly. Rotate the platter until the
brass motor spindle is visible through one of the holes. Check to make sure that it rotates
uniformly and does not wobble excessively.
3. Pass your fingers through the hole, grip the rubber drive belt and install it over the motor
spindle. Be careful not to twist the rubber drive belt during this step. Check to make sure
the platter rotates uniformly. If the drive belt is properly installed, there should be a slight
amount of tension that brings the platter to a stop after spinning it freely.
AUDACITY SOFTWARE OVERVIEW
Note: please ensure you have installed the software before starting.
Setting up your PC to work with Audacity
1. Connect an input source to the unit
2. Connect the USB lead to your computer
3. Install the Audacity recording software
4. Open the Audacity program
5. Select preference from the Edit tab in the Audacity menu
13