Krüger & Matz TT-602 Mode D'emploi page 11

Owner's manual
• White (L+) Left channel +
• Blue (L -) Left channel –
• Red (R+) Right channel+
• Green (R-) Right channel –
5. Headshell locking nut
Attach the head shell by inserting it into the front end of the tone arm and then turn the locking
nut clockwise.
6. Tone arm
Fully manual tone arm. To start playback, gently place the stylus on the record using head shell
finger support OR use the tone arm lifter.
7. Tonearm lift
Controls the up and down action of the tone arm.
8. Anti-skate knob
Applies inward force to the tone arm so it doesn't skip outwards across the record due to the
centrifugal force of the record spinning.
9. Counterweight
Adjustment creates the proper downward pressure of the stylus to the record. Attach now
by sliding the counterweight onto the rear of the tone arm. Twist it lightly and it will screw
onto the rear shaft of the tone arm. Counterweight adjustment: bring tone arm in 0-level with
counterweight. When leveled set scale on counterweight to 0 (watch the stripe). Now turn the
counterweight until it shows the specified downward pressure in gram.
10. Ground
11. Output L & R
Standard analog output (RCA jacks) which can be connected either to phone or line input on
any Dj mixer, depending on the setting of the phone/line selector.
12. Audio select
Audio selection button
13. USB port
plug USB device.
14. power cord connector
15. power ON/OFF switch
AUDACITY SOFTWARE OVERVIEW
Note: please ensure you have installed the software before starting.
Setting up your PC to work with Audacity
1. Connect an input source to the unit
2. Connect the USB lead to your computer
3. Open the Audacity program
4. Select preference from the Edit tab in the Audacity menu
11