Rip curl Function. Mode D'emploi page 2

English
Function. Dual Time with Timer, Chronograph, Alarm & Light
Display
MODE
To Set Time 1
1. In Time mode, ensure T1 or TIME 1 (depending
on your watch model) is showing on-screen. This
indicates you are in TIME 1 mode.
2. Hold LIGHT for 2 seconds.
3. Push MODE twice to enter the time setting
mode.
4. The Hour Format will be flashing. Push
START/STOP to select 12HR or 24HR format.
5. Push MODE to advance to Hour. Once flash-
ing, push or hold START/STOP or LAP/RESET to
increase or decrease Hour.
6. Repeat to advance through and set Minutes,
reset Seconds to zero, set Year, Date Format
(Day-Date or Date-Day), Month, and Day.
7. At any point, push LIGHT to finish the setting
and exit the time setting mode.
To Set Time 2 (Dual Time)
1. In TIME 1, hold START/STOP for 2 seconds to
enter T2 or TIME 2 mode.
2. Hold LIGHT for 2 seconds to enter Dual Time
setting mode.
LIGHT START/STOP
LAP/RESET
3. Push or hold START/STOP or LAP/RESET to
increase or decrease the time di erence
between TIME 1 and TIME 2.
4. Push LIGHT to finish the setting and exit the
time setting mode.
Tip: to toggle between TIME 1 and TIME 2, hold
START/STOP for less than 2 seconds.
To Set Daily Alarm
1. In TIME 1 mode, push MODE 3 times to enter
Alarm mode.
2. Push START/STOP to select between 4 inde-
pendent alarms to set.
3. Hold LIGHT for 2 seconds to set the Hour.
Once flashing, push or hold START/STOP or
LAP/RESET to increase or decrease Hour.
4. Push MODE to advance to Minutes. Once
flashing, push or hold START/STOP or LAP/RE-
SET to increase or decrease Minutes.
5. Push LIGHT to finish the setting.
Tip: When setting the alarm, it will default to
"ON". Push LAP/RESET to toggle alarm on or o
after finishing the setting. When on, the alarm