Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
AeroFlow® Surface storage heater with FlexiSmart thermostat
Manual for FlexiSmart Controller
4
Backlight
After commissioning, the status display appears and the display is
illuminated. After 30 seconds without use, the lighting will turn off
disabled. To reactivate the backlight, press OK.
Change language
Press OK. With the arrow keys you can go to „Configuration" and
press OK.
With the arrow keys you can go to„Sprache" and press OK.
Select the language and press OK.
After this, use the arrow keys to go to „Back" and press OK.
Then you are back on the status display.
The first menu you will see after switching your AeroFlow
show the current time on the top left (for setting see page 11). The large
temperature next to the thermometer icon shows the current room tem-
perature. The small temperature in the lower right corner shows the
target temperature.
Depending on the program setting, the following icons are visible:
Manual mode (program mode Off). The target temperature
will be controlled via the arrow buttons.
The AeroFlow
heater is in program mode.
®
The radiator is about to warm the room. As soon as the set
room temperature is reached, this symbol disappears.
Open window detected, the AeroFlow
switched off.
Holiday Mode: The digit below the icon indicates the
number of remaining holidays (see page 10).
Keylock/Childlock ON (to enable/disable press both arrow
buttons simultaneously for min. 5 sec.
Turn off the radiator / Standby mode
To turn the heater off, keep the OK button pressed for at least 5 se-
conds. „Standby" will be displayed. After this, the display will be dark.
Power consumption in standby mode below 0.1 watts. To quit the
standby mode, press the OK button.
NOTES:
If the clock symbol (program mode) is not displayed, lower or raise the
target temperature by using the arrow buttons. The AeroFlow
will always hold this temperature. In case the program mode is enabled
(the clock symbol is displayed), the target temperature can also be lo-
wered and raised with the arrow buttons. The manually set target tem-
perature overrides the program mode until the next preset start or end
time of a time frame. The AeroFlow
after then.
The display view changes after 5 seconds without pressing a button.
The current temperature is displayed on the top and the target
temperature at the bottom.
Menu navigation
After the status display, the further menu is divided into 4 levels, which
are reached by confirming the individual menu items.
heater will
®
heater is temporarily
®
heater
®
heater returns to program mode
®
12:34
12:34
21
°C
.7
15.5 °C
Configuration
Language
Mode active:
Manual mode
Program mode
Holiday mode
Function aktive:
Radiator warms
Open window detected
STANDBY
Press ok....
Status display
12:34
21
°C
.7
15.5 °C
21.7 °C
15
°C
.5
Level
Level
1
2
10
Status display
21
°C
.7
15.5 °C
english
Language
Time
Room temperature
Keylock ON
Set room
temperature
12:34
21
°C
.7
15.5 °C
OK
Arrow up
Arrow down
and left
and right
Confirmation
button
Temperature overview
Level
Level
3
4
www.thermotec.ag
Publicité
