Publicité
Les langues disponibles
Les langues disponibles
1. If equipped remove (2) plastic underbody panels, 1 each side located under the rear bumper and behind the rear wheels. Using a standard screwdriver, remove
(3) plastic expansion fasteners from each panel and pull down to remove. Set aside for reinstallation later.
2. Start by inserting the hitch over the tailpipe on the passenger side. Note: removing the rubber isolators and lowering the exhaust may make this easier. Rotate
the hitch and raise into position. Install (4) M10 x 1.25 X 30mm Cl10.9 bolts and conical toothed washers (teeth side against hitch) on the passenger side and (3)
M10 x 1.25 X 30mm Cl10.9 bolts and conical toothed washers (teeth side against hitch) on the driver side.
©2015, 2021 Horizon Global™ Corp. - Printed in Mexico
Sheet 4 of 15
75836NP
09-02-21
Rev. B
Publicité
