Publicité
Les langues disponibles
Les langues disponibles
base of the machine when feeding
EN
material into it.
5. Always stand clear of the discharge
zone when operating this machine.
6. When feeding material into the
machine be extremely careful that
pieces of metal, rocks, bottles, cans
or other foreign objects are not
included.
7. If the cutting mechanism strikes
any foreign objects or if the
machine should start making
any unusual noise or vibration,
immediately shut off the power
source and allow the machine
to stop. Disconnect the machine
from the supply and take the
following steps before restarting
and operating the machine:
i) inspect for damage;
ii) replace or repair any damaged
parts;
iii) check for and tighten any loose
parts.
8. Do not allow processed material to
build up in the discharge zone; this
may prevent proper discharge and
can result in kickback of material
through the intake opening.
9. If the machine becomes clogged,
shut-off the power source and
disconnect the machine from
supply before cleaning debris.
10.Never operate the machine with
defective guards or shields,
or without safety devices, for
example debris collector in place.
SAFETY INSTRUCTIONS
38
11.Keep the power source clean of
debris and other accumulations
to prevent damage to the power
source or possible fire.
12.Do not transport this machine
while the power source is running.
13.Stop the machine, and remove
plug from the socket.
Disconnect the supply and make
sure that all moving parts have
come to a complete stop
- whenever you leave the machine,
- before clearing blockages or
unclogging chute,
- before checking, cleaning or
working on the machine.
14.Do not tilt the machine while the
power source is running.
Follow below recommendations
when using the product:
1. Operate the machine only at
reasonable hours – not early in
the morning or late at night when
people might be disturbed.
2. Use rakes and brooms to loosen
debris before blowing/vacuuming.
3. Slightly dampen surfaces in
dust conditions or use mister
attachment.
4. Use the full blower nozzle
extension
5. Supply the product via a residual
current device (RCD) with a
tripping current of not more than
30mA.
Publicité
