ultega 830700000008 Manuel D'instructions page 10

FOLDING TRAMPOLINE
ASSEMBLY STEP
STEP 2 : NOTE - Make sure the SECURE PIN (10) is inserted into the end of RAIL (1) and properly secured by the
Wire Ring. Both ends of the SECURE PIN (10) should have approximately 1/8 inch between the RAIL (1)
and the Wire Ring. Refer to illustration 2.
STOP!
• ALWAYS USE TWO OR MORE STRONG PEOPLE TO UNFOLD OR FOLD THE ULTEGA FOLDING
TRAMPOLINE. FAILURE TO USE TWO OR MORE STRONG PEOPLEMAY ALLOW THE RAILS TO
SPRING BACK INTO THE FOLDED POSITION AND STRIKE SOMEONE WHICH CAN CAUSE SERIOUS
BODILY INJURY OR DEATH.
• Keep fingers away from the ends of the rails in the hinge area when unfolding the ULTEGA FOLDING
TRAMPOLINE. Serious injury can occur if fingers are caught between the endsof the RAILS.
Hold RAILS (3, 4) and push down on RAILS (1, 2) to unfold the ULTEGA FOLDING TRAMPOLINE to the flat position.
The RAILS (1, 4) and RAILS (2, 3) should snap together and be locked by the SECURE PIN (10) when you reach the flat
position. Refer to illustration 2.
STEP 3 : Slide the SAFETY PAD (6) over the rail frame. Make sure the holes in SAFETY PAD (6) fit over
the threaded connectors properly. Refer to illustration 3.
HINT : Install one hole over a threaded connector. The next hole installed should be on the connector on the
opposite side of the trampoline.
CAUTION : The SAFETY PAD (6) must be securely attached to the rail frame in the correct position. All six (6) holes
in the SAFETY PAD (6) must fit over a threaded connector on the rail frame as shown in illustration 4
on the following page. The SAFETY PAD (6) must also cover the springs on the MAT (5) as shown in
illustratration 5 on the following page.
. 2
Hazard label on trampoline surface reads as follows:
! WARNING!
PREVENT serious INJURY or DEATH.
Rails can SPRING back and STRIKE someone.
ALWAYS fold and unfold carefully with TWO or more
STRONG people.
Do NOT remove this tag.
US 8
. 3
install the Safety Pad (6) on
Bracket
Guide
to this Threaded Connector.
Second Step,
B.
install the Safety Pad (6) on
to this Threaded connector.
A. First step,