Publicité
Les langues disponibles
Les langues disponibles
17 Troubleshooting
17.1 Causes and rectification of faults
Problems
The compressor
makes a buzzing
noise
Ice full indicator light
on but with less ice in
the basket
Lack of water
indicator is on but
water tank has a lot
of water
Power light is off
when switching on
The lack of water
indicator and ice full
indicator flash at the
same time
17.2 Safety notices
caso Ice Master
All manuals and user guides at all-guides.com
This chapter provides you with important notices with regard to
operating the device. Observe the following notices to avoid
dangers and damages:
The following table assists in localizing and rectifying minor
faults.
Reasons
too low voltage
Room temperature is too low
the sensor was broken
the sensor is broken
water conductivity less
unit is not plugged properly
the fuse on the PCB was
burnt
Synchronous motor is
detected
The ice cube is too big and
stick together and can not
drop off from the
evaporator
► Only qualified electricians, who have been trained by the
manufacturer, may carry out any repairs on electrical
equipment.
Troubleshooting
Solutions
Turn off the ice maker.
Make sure the voltage is on
normal and restart.
Take out the ice basket and put it
back until the light is off
send to Service departement
send to Service departement
add little salt
check and ensure the unit is
properly plugged
send to Service departement
send to Service departement
Turn off the unit and wait for the
melting of the ice, restart the
unit, select smaller size of ice
mode
Attention
44
Publicité
