Publicité
Les langues disponibles
Les langues disponibles
13.3 Transportation
13.4 Setup location requirements:
caso Ice Master
All manuals and user guides at all-guides.com
When moving the unit, please grasp the handle grip and pay
attention that the unit is not sloped over 45°.
.
Warning
Property damages can occur during transportation of the
device!
Observe the following safety notices to avoid such dangers:
► The incline angle of the machine do not be over 45° during
transportation.
► Do not turn the ice maker upside-down, in case cause the
compressor or refrigerating system to operate incorrectly.
► Don´t move the device during commissioning.
In order to ensure the safe and trouble-free operation of the
device, the setup location must fulfil the following prerequisites:
The device must be set up on a firm, flat, horizontal and water-
resistant surface with sufficient load-bearing capacity for the ice
maker and 0,5 l water.
Choose the setup location in such a way that children cannot
reach the device.
The device is not intended to be installed in a wall or a built-in
cupboard.
Do not set up the device in a hot, wet or extremely damp
environment or near flammable material.
The device requires an adequate flow of air in order to operate
correctly. Leave a clearance of 15 cm on all sides.
Do not cover up any openings on the device and do not block
these off.
Do not remove the device's adjustable feet.
The electrical socket must be easily accessible so that the
power lead can be disconnected easily, in the case of an
emergency.
The installation and assembly of this device in non-stationary
setup locations (e.g. on ships) must be carried out by specialist
companies / electricians, provided they guarantee the
prerequisites for the safe use of this device.
Commissioning
36
Publicité
