Intellinet IMCI-SMSCG20KM Instructions page 2

Instructions
Media converters connect two Ethernet networks over a longer distance using fiber optic cable.
For specifications, visit intellinetnetwork.com. Register your product at
register.intellinet-network.com/r/508346 or scan the QR code on the cover.
Features
• One 10/100/1000 RJ45 port supporting a maximum distance of 100 m (300 ft.)
• One 1000Base-LX fiber SC single-mode port supporting a maximum distance of 20 km (12.4 mi.)
• IP40 slim-type metal housing to withstand harsh industrial conditions
• Option for DIN-rail installation
• Two redundant DC inputs (12 - 58 V) with I/O terminal block
Connections
Twisted Pair – RJ45
Connect the UTP port of the media converter to an
RJ45 port on the network (e.g., to an Ethernet switch).
Cat5e or better cabling is recommended.
Fiber Optic
As shown, two fiber optic cables need to be connected
between two ideally identical media converters.
Make a connection from Media Converter 1 TX to Media Converter 2 RX, and from Media Converter 1 RX to
Media Converter 2 TX. Maximum length and fiber cable specification depend on the model. (See Models.)
Front panel
Item
RJ45 Port
P — Power
O — Optical Fiber Port
A — Alarm
N — NMC
2 English
All manuals and user guides at all-guides.com
LED Color
Port activity Green
Speed Yellow
Power and power-
supply-under-voltage
alarm (priority of Green
under-voltage alarm is
higher than power LED)
Fiber port and power
supply overvoltage alarm
(priority for overvoltage Green
alarm is higher than fiber
port Link/Act LED)
Device alarm and data
Red
transmission indicator
Management indicator
Green
and data receiving
Gigabit Industrial Media Converter
MEDIA CONVERTER 1
ETHERNET 1
TWISTED PAIR
Status
Flashing Sending or receiving data.
On Port is connected.
Off Port is not connected.
On 1000 Mbps speed.
Off 10/100 Mbps speed.
Flashing Equipment power supply is lower than the lower limit of the
every 1s input range of DC 12 V, indicating an under-voltage alarm.
On Power channel is powered.
Off Power channel is not powered.
Flashing The power supply of the device exceeds the upper limit of the
every 0.5s input range of DC 58 V, indicating an overvoltage alarm.
On Fiber port is connected.
Off Fiber port is not connected.
Flashing Sending or receiving data.
Console/RS232/RS485 port is sending data (LED
Flashing
flashes to the rhythm of data being sent).
On An issue has been detected (temperature, dying gasp, etc.).
Off No alarm issue detected.
Console/RS232/RS485 port is receiving data (LED
Flashing
flashes to the rhythm of data being received).
On Module embedded and initialization is complete.
Off No embedded module.
Example
TWISTED PAIR
TX RX RJ45
ETHERNET 2
OPTICAL FIBER
RX RJ45
TX
MEDIA CONVERTER 2
Description