Skullcandy TuneUps Manuel Du Propriétaire page 4

GETTING STARTED
Connecting TuneUps to your helmet and Music
Source
Perform these steps to connect your TuneUps.
1. Open the audio pocket on each earpad, remove the
round pieces of foam padding, and slip in our Audio
Drops speakers.
6
All manuals and user guides at all-guides.com
2. Slip the short headset jack from the speakers through
the hole at the bottom of either earpad.
Note: If you purchased a Giro Audio Series Helmet
already equipped with Audio Drops speakers,
please skip to Step 4.
3. Tuck the audio wire connecting both speakers either
under the padding inside the back of the helmet or inside
the neckroll pocket, depending on the helmet model.
4. Connect your TuneUps cable to the Audio Drops
speakers using the 3.5mm stereo audio cable. Tuck the
headset jack back up into the earpad, if desired.
5. To listen to music, simply connect your music source
to the 3.5mm stereo audio cable.
7