Energetics E-202 Manuel D'instructions page 7

[» 2] Setting and selection of the training parameters
The computer is in the display mode, when it restarts form the sleep mode, or the values have been reset using
the die RESET-key or during the workout . The display shows SCAN .
By pressing the MODE key you enter the setting mode . SCAN is no longer displayed .
!
When in the display mode the readout of the individual parameter blink, in the setting mode
they do not.
You will see the readout STOP (no activity) and in the main display the value for the selected workout time (TIME) .
The readouts for other the parameters (distance and calories) to be set can be reach by pressing the MODE-key
again . The computer will also show parameters that cannot be set (ODO, heart rate, speed) . These can be skipped
by pressing the MODE-key .
!
During the workout the settings can only be changed when the unit is idle. Changes can be
made only when STOP appears, using the MODE and SET-key.
Setting of functions
Start the computer by pressing any key . The computer scans through all values (showing each for 6 seconds) . The
computer is in the display mode .
!
Depending on which value is displayed when the MODE-key is pressed and the setting mode
is entered, the sequence of the settings is changed.
• To change into the setting mode press the MODE-key . SCAN is no longer visible .
• Press the MODE-key again and the workout time is displayed . Press the SET-key until the desired time in
displayed .
• When the workout time is set press the MODE-key . Now calories (CAL) is displayed . Press the SET-key until the
desired Kilojoules value to be used is displayed .
4
All manuals and user guides at all-guides.com
• After the calorie value is set press the MODE-key four times . The display will switch to ODO (not adjustable),
then PULSE (not adjustable), then speed (not adjustable) and finally workout distance . Press the SET-key until
the desired workout distance is displayed .
• When the workout distance is set press the MODE-key . The computer switches back to the display mode .
Now the workout can begin .
A workout time between 1 and 99 minutes can be selected . The time can be entered in increments of one minute .
If a value for time is entered, the time will count down to 0 . A beep tone signals when 0:00 is reached .
If the value of the setting is left at 0:00, the time counts up and the current value is displayed .
Shows the approximate value of kilocalories used . The kilocalories to be burned during the work out can be
selected between 1 . 0 and 9990 and entered in increments of 1 and 10 .
• Entered in increments of 1 kilocalorie up to the value of 1000 kilocalories
• Above 1000 kilocalories in increments of 10 kilocalories
If a value is entered the kilocalories used count down . A beep tone signals when 0 . 0 value is reached .
If the value of the setting is left at 0 . 0 , the kilocalories used counts up and the current value is displayed .
A workout distance can be selected between 0,1 km and 999 km .
• Entered in increments of 0,1 up to a value of 100 kilometres
• Above 100 Kilometres increments of 1,0 kilometres
If a value for distance is entered the kilometres travelled count down . A beep tone signals when 0 . 0 is reached .
If the value of the setting is left at 0 . 0 , the distance counts up and the current value is displayed .
Workout time
TIME
Calories used
CAL
Workout distance
DIST